• Spray applied, solvent-based contact adhesive designed for economy and e iciency for flatwork (non- postforming) high-speed applications
• Aggressive tack and rapid high-strength bonds
• Professional use only
• Does NOT require stirring before use
• Meets or exceeds:- Commercial Item Description A-A-1936A (1996); Type I-B (supersedes Fed. Spec. MMM-A-130b)- Woodwork Inst. of Cal. Type II adhesive- Mil. Spec. MIL-A-21366A

Applications to Avoid

• Copper, or copper alloy, substrates
• Copper spray system or fluid components
• Surfaces with dirt, grease or excessive moisture
• Vinyl surfaces containing plasticizers which may attack the bond line (conduct pre-testing if in doubt)

Availability

• 5 gallon pail
• 55-gallon drum and 330-gallon tote are available through calling for quote request

Storage/Shelf Life

• Rotate stock and close container when not in use.  Store on floor in a cool, well ventilated area and away from exterior walls.
• Shelf life expires 1 year from manufacture date.
• Product may separate after exposure to extreme cold requiring agitation after return to normal temperature.

Coverage Instructions

Cover a minimum of 2.0 dry grams/ft 2 on both surfaces.

General Use Instructions

• DO NOT U SE THIS PRODUCT IF YOU HAVE NOT READ OR DO NOT UNDERSTAND THE WARNINGS, SAFETY MEASURES, AND FIRST AID INSTRUCTIONS PRINTED ON THE CONTAINER OR LABEL. For best results, do not apply the adhesive at temperatures below 65°F.
• Ensure spray system oil and water traps are functioning and are at least 25' from compressor. Allow substrates to acclimate to room temperature for 48 hours before bonding. Assemble glued parts at or above 65°F and ensure each surface is clean and dry.
• Apply adhesive uniformly to both surfaces in a smooth, pebbled pattern and cover each surface a minimum of 80%. Cover edges 100%. Some porous surfaces may require two (2) coats.
• Allow approx. 3-5 minutes to dry after application and before bonding. When ready to bond, surface will be tacky but should not transfer or "leg" to a firmly pressed fingertip. If parts don't stick immediately, they are over-dry and can be reactivated by applying a light coat of fresh adhesive on both parts.  Open time is approximately 60 minutes.
• Apply uniform downward pressure (30-40 psi minimum) across the entire bonded surface by mechanical pinch roller (recommended) or  by using a 3” wide rubber J-roller. Use of a wooden block or other hand rollers is not recommended.
• Immediate trimming, routing or finishing is possible.
• DO NOT THIN THIS PRODUCT.

Clean-up/Disposal

• Clean equipment with Wilsonart WA 110  Solvent and finished assembly with WA 121 Cleaner.
• Dispose of waste in accordance with regulations